seti with cuda

cuda work perfectly with seti
I resolved the problem, but it is strictly personnal
there is 2 solutions.

1. you detach seti in boinc. you active seti a new time and seti load cuda driver for seti. it install itself and can find a new ressource.

2. you must locate manually the conflict ( as i made ) it is very easy. =>

command => execute => enter: msinfo32 ( wait it load )

you go in ressource material => conflict/ partage => if there is a conflict, 2 or 3 peripheral use the same IRQ.

solution => run "control panel" => gestion peripheral. select incriminated peripheral and with right\mouse botton deactive it ( not the graphic card of course )

explaination for my computer: IRQ 16 controleur universel Intel(R) 82801G ICH Family USB - 27CB
IRQ 16 NVIDIA DeForce 9500 GT
IRQ 16 Controleur Audio High definition

so you deactivate in usb bus controleur => 27CB only ( if there is a mouse or a keyboard, change the usb plug )
you deactivate sound controler => right\mouse on audio for making it, but the best way is to make it in the bios at the boot of the computer.

reboot and then cuda work perfectly with gaphic card ( no bug, full speed ok!)

you need also to deactivate ACPI, but if you reboot, system automatically reinstall it because of the plug and play ( you must stop the service upnp for it)

Attention!!! ACPI can save your material. you must have a good program as Speedfan 4.38 to survey, temperature!!! it could be catastrophic!!!

but ACPI is not good for computing linearly with universal data, because it permanently change frequencies and voltage of computer and other hardware.

So you can not use the harmonisation of CPU/FREQ like 1,420 Mhz ( it is possible, but it is difficult to make, but not impossible, nothing is impossible for believers).

Thank for your attention.

The King Of Ukog

---

" All The Universe sings the Praises Of Your Lord, but you do not understand its singing(song) ".