If you have installed the librarys I have posted in my last postings, you can also attach with the boinc manager :

2006-03-18 08:48:16 [---] Starting BOINC client version 4.43 for sparc-sun-solaris2.7
2006-03-18 08:48:16 [---] Data directory: /BOINC
2006-03-18 08:48:16 [---] No general preferences found - using BOINC defaults
2006-03-18 08:48:16 [---] Remote control not allowed; using loopback address
2006-03-18 08:48:16 [---] Insufficient work; requesting more


that is what I was getting from the client

Can you please post the complete output beginning from the startup.
Also it is better to start the boinc_client from a terminal, and not with the filemanager.
It could also be, that in your boinc directory are two files called stderrdae.txt and stdoutdae.txt. - If the two files exist, can you please post the output, too.

In your computers list are no solaris system shown, so it looks like something going wrong with the attachment to the project...

Also it is better to start the boinc_client from a terminal, and not with the filemanager.

ok, I figured out how to get the cmd line working but not sure how to enter my information

At the boinc wiwki : http://boinc-wiki.ath.cx/index.php?title=Main_Page is almost everything documented. - There are also a lot of good install dokumentations.

You need to attach to the project with this command : " boinc_client -attach_project http://setiathome.berkely.edu $ACCOUNT_KEY" <- Change $ACCOUNT_KEY in the command in the accountkey, you get from the project per email.