Joined: 27 May 99
Notice that one of my tasks is now at 3 hours elapsed: 03:16:47
SETI@home 8.22 SETI@home v8 (opencl_ati5_SoG_nocal) 0.0463C + 1ATI (d2) 94.1 03:16:47 (03:05:14) 00:09:44 rx560 21au19aa.29610.1703.11.38.45_1 SETI@home 8.22 SETI@home v8 (opencl_ati5_nocal) 0.0463C + 1ATI (d1) 5.75 00:19:02 (00:01:05) 00:02:10 rx560 21au19aa.31145.504184.108.40.206.vlar_1 SETI@home 8.22 SETI@home v8 (opencl_ati5_nocal) 0.0463C + 1ATI (d4) 5.95 00:17:13 (00:01:01) 00:03:03 rx560 21au19aa.16733.472220.127.116.11.vlar_0 SETI@home 8.22 SETI@home v8 (opencl_ati5_nocal) 0.0463C + 1ATI (d0) 6.04 00:16:42 (00:01:00) 00:03:17 rx560 21au19aa.32315.42218.104.22.168.vlar_0 SETI@home 8.22 SETI@home v8 (opencl_ati5_nocal) 0.0463C + 1ATI (d3) 6.42 00:15:05 (00:00:58) 00:03:26 rx560 21au19aa.32315.42222.214.171.124.vlar_1
I then went over to all my tasks and looked at all "errors"
sure enough, looks like the no_cal have a problem. Under preferences there is no option to prevent no_cal from downloading. Any suggestions? Using boinctasks I can set a timeout but eventually I got to go in there and abort them manually.
The AP errors were because I failed to install the OpenCL library on that nVidia system. Not sure why just the nocal fail on this ATI system.
[EDIT] Just discovered that if I suspend and then resume, the task goes on to finish just fine.
1. Suspend: after a few seconds the GPU gets another task.
2. Resume: after a few minutes one of the other tasks completes and the formerly suspended one picks up. I notice the 3 hour elapsed time is gone and is replaced with only a few minutes. that is inconsistent. if 3 hours wall clock elapsed why did it revert back to 0 or whatever? Anyway, it finished and uploaded. Do not know if it is to error out as it is hard to lookup those tasks once uploaded.
©2022 University of California
SETI@home and Astropulse are funded by grants from the National Science Foundation, NASA, and donations from SETI@home volunteers. AstroPulse is funded in part by the NSF through grant AST-0307956.