I see that the RTS is almost empty. Splitters never did take off after the outage. I wonder if it has anything to do with the Resend Lost Tasks, the first two tasks that I got were the two Ghosts that I had. Of course they could just need a size twelve applied to the right spot. The guys will get them going when they come in.

. . It's nice to get ghost resends without the rigmarole ...

Stephen

:)

I see that the RTS is almost empty. Splitters never did take off after the outage. I wonder if it has anything to do with the Resend Lost Tasks, the first two tasks that I got were the two Ghosts that I had. Of course they could just need a size twelve applied to the right spot. The guys will get them going when they come in.

. . It's nice to get ghost resends without the rigmarole ...

Stephen

:)

This is good to hear as it will also decrease the database size

---

Splitter output still poor, but good enough to stop the Ready-to-send buffer from emptying out, at this stage.

---

Grant
Darwin NT

Splitter output still poor, but good enough to stop the Ready-to-send buffer from emptying out, at this stage.

Well, that was the case. Ready-to-send buffer has gone from falling slightly, to taking a dive. 2-3 hours work left at current rate of decline.
Post outage splitter woes continue.

---

Grant
Darwin NT

Results ready to send	0	0	18,924	0m
Current result creation rate **	0/sec	0.0168/sec	16.2886/sec

Do we have a problem?

---

Depends whether your cache will hold out until sunrise...

Results ready to send	0	0	18,924	0m
Current result creation rate **	0/sec	0.0168/sec	16.2886/sec

Do we have a problem?

I think the current status would qualify as a problem.....yes.
Meowsigh.

---

"Freedom is just Chaos, with better lighting." Alan Dean Foster

Ity might be time to boot all the splitters in the bum (I.E. re-boot ther splitter program) as when I checked, there were only 2.4k WU to send out and the creation rate was only 24/sec...
Normally with that few WU, the creation rate would be up in the 50/sec range!

But at least some WU's are being created...

---

.

Hello, from Albany, CA!...

Results ready to send	0	0	1	0m
Current result creation rate **	0/sec	0.0242/sec	29.2642/sec	6m

I think the current status would qualify as a problem.....yes.

Now I'm sure we have a problem. LOL

At least my WU & beer caches are full.

---

It's guided from certain keywords in the twitter feed from a president of a known country :-)

Then we're all screwed.

RTS says we are all screwed.

---

I wouldn't say splitter output is better than it was, just that it's not as bad as it has been.

---

Grant
Darwin NT

I wouldn't say splitter output is better than it was, just that it's not as bad as it has been.

That's why I suggested re-booting ALL the splitters...

---

.

Hello, from Albany, CA!...

Splitters are still barely functioning. Not looking good for the weekend.

---

Grant
Darwin NT

Ready-to-send is now down to 1.
Will we get another dead cat bounce, or is it now down for the count?

---

Grant
Darwin NT

It's probably safe to mention it now, but for a while there the splitters actually cranked up their output & the Ready-to-send buffer actually end up with some work in it. Then not only did they fall over again, but their output is even less than it was before that little burst of activity. Present load is just under 120k per hour. Present splitter output less than 56k per hour.
So expect to run out of work over the next few hours, unless we get lucky again.


EDIT- just noticed 42 channels on one file have all errored out. Bad data, or more server problems, hence the poor splitter output?
Now 43.

---

Grant
Darwin NT

Now 43.

Now 49.

Looks like that entire file is going in to the bit bin.
Might be worth Eric's while to check it out on Monday.

Now 52
File name is
blc12_2bit_blc12_guppi_58157_16456_DIAG_PSR_J1024-0719_0006
in case it's gone when Eric gets a chance to look at it.

---

Grant
Darwin NT

Sat 26 May 2018 11:00:30 AM EST | SETI@home | Requesting new tasks for CPU and NVIDIA GPU
Sat 26 May 2018 11:00:40 AM EST | SETI@home | Scheduler request completed: got 0 new tasks
Sat 26 May 2018 11:00:40 AM EST | SETI@home | Project has no tasks available

Last few request for new work ends on this.

---

Results ready to send 0 0 162 0m

---

Yup. The splitters be lollygaggin'.
Meowsigh.

---

"Freedom is just Chaos, with better lighting." Alan Dean Foster