command line "gui" for Raspberry Pi

Questions and Answers : Unix/Linux : command line "gui" for Raspberry Pi
Message board moderation

To post messages, you must log in.

AuthorMessage
Profile The Jedi Alliance - ^WarHawk^

Send message
Joined: 25 Jun 99
Posts: 29
Credit: 33,205,318
RAC: 77
United States
Message 1796940 - Posted: 17 Jun 2016, 22:53:25 UTC

I compiled and created a binary for armhf architecture with the permission of the creator Sergey Suslov



I had to import about 5 missing lib files and install autoconf to get it to compile, then used checkinstall vs make install to build the binary

download from dropbox
https://www.dropbox.com/sh/3ky292a5amv22kc/AAAk_mSVuZYE1Uok0Ae0c8j3a?dl=0

Per Sergey's directions

You need some steps to configure boinc for allow remote connections.

1. check file remote_hosts.cfg at boinc config directory. Add ip address of host there boinctui will be placed (127.0.0.1 for localhost)

2. edit (or create if not exist) file gui_rpc_auth.cfg in same directory add password (plain text) to this file

3. restart boinc

4. be sure that boinc listen tcp port

netstat -apn | grep boinc

5. try run boinctui again. Set proper host, port and password to boinctui config form.

ID: 1796940 · Report as offensive
Profile The Jedi Alliance - ^WarHawk^

Send message
Joined: 25 Jun 99
Posts: 29
Credit: 33,205,318
RAC: 77
United States
Message 1796979 - Posted: 18 Jun 2016, 1:42:28 UTC

FYI in case you didn't know the boinc config directory

is

/var/lib/boinc-client

ID: 1796979 · Report as offensive

Questions and Answers : Unix/Linux : command line "gui" for Raspberry Pi


 
©2024 University of California
 
SETI@home and Astropulse are funded by grants from the National Science Foundation, NASA, and donations from SETI@home volunteers. AstroPulse is funded in part by the NSF through grant AST-0307956.